This condenser was made for a Smith Beck and Beck. A 1/4″ objective was used as a condenser lens and a tiny aperture iris was obtained. The aperture iris and condenser were fixed inside a ring with centering screws (see gallery below for images) and the objective was attached via an RMS thread. The rack which carries the condenser unit was attached to another ring clamped onto the bottom of the stage (which originally carried the aperture wheel). This was convenient because the new condenser could be removed easily and the original aperture wheel reattached, no permanent alterations are required.
The original mirror was positioned in such a way that there was insufficient travel for the condenser on the rack, insufficient travel made the whole thing rather pointless so to overcome this a small sliding tube was inserted inside the tube which carried the original mirror – once again avoiding the need to make any permanent changes to the microscope. The new tube was turned down so that it had a marginally smaller outer diameter than the original one in the manner of an aerial. The new tube can be pulled down from inside the original tube when required and pushes back up to allow the microscope to be stored in the upright position.
A coat of lacquer and the new condenser was magically transformed! I think Beck would be happy.
Click on thumbnails to enlarge
